Installation and connection
The space in the bathroom is divided into four zones:
- Zero direct contact with water (bathtub or shower).
- The first shower. The distance from the bathtub or the shower enclosure perimeter is 1015 cm, where there is a risk of splashing. A device with at least IPx7 protection will be necessary.
- Second coverage around the 1st zone in a circle, starting at 60 cm and going to the height of the bathroom. Slight risk of vertical splash backs. Electrical equipment with IPx4 or higher protection rating is suitable.
- The third section outside of the second zone, a relatively safe place to install the electrical device and connect to the network with splash protection and the mandatory installation of RCD.
Attention! If using an electric dryer with a mains connection or with a thermostat installed on the plug, the length of the wire is important.
The socket should be installed in zone 3, and the towel rail should be placed in zone 2 or 1, depending on the degree of protection of the enclosure. It is better to locate the towel dryer in the third zone, so that the splashing does not fall on the device.
At what height hangs
- The main point in the location of the equipment is moisture resistance.
- Installation of the device is performed at the distance of not less than 120 cm from the floor, it is necessary to give a distance of at least 60 cm from the sanitary equipment.
- The electric towel dryer can be placed over the washing machine, but in such a way that there is no interference with the loading of laundry in the frontal location of the cover.
- When locating the ladder dryer, an adult’s height should be taken into account for free access to the upper bar.
How to accurately make holes in the tiles
If possible, place the appliance close to the ventilation grille or between the door and the hood. For fastening of a towel dryer two to four points are provided.
These are plates or brackets with holes for mounting, which are covered with decorative plugs. The most often used dowels for screws 6×60.
In order to install an electric towel rail on the tile, you must consider the order of drilling holes in the tile:
- Use a marker to mark the points on the tile;
- Carefully beat the enamel in the marked point with a drill at low speed or use the tip of a file for this purpose;
- If you can not beat the enamel, then you should glue a piece of tape on the place of drilling, so that the drill when working does not slip;
- Drill the tiles in a hammerless mode;
- Drill into the wall with the highest pressure;
- after all the holes are formed, plastic dowels are inserted or hammered into them with a soft mallet.
Important! If the installation is carried out before laying tiles in the bathroom, then you should pay attention to the rules of laying cables and installing outlets in wet areas.
How to make a hole for the socket and install it
To do this, you need to do the following steps:
- Using a drill to make holes for fasteners, mostly dowels are used;
- Strip the ends of the wires from the insulation;
- to install dowels in the prepared span;
- in the holes with rubber stoppers to pass the wires;
- connect the bare wire ends to the socket;
- Fix the body of the socket on the wall, fix it tightly;
- tighten the fastening screws;
- Apply voltage to the socket and check the work.
Fastening to the wall
At first the marking is made:
- Attach the towel rail or mounting plate to the wall so that the main parts of the device are at an acceptable height.
- Mark the position of one upper fixture. A plumb line or level is useful here, then from the marked point you need to draw a vertical and horizontal line directly into the level.
- To put a towel dryer so that the place of the first marked fastening coincides, and also to combine 2 adjacent fastenings with lines, to mark their positions on a wall.
- Using a plumb line and/or level, determine the location of the fourth point of attachment, then complete the marking to the correct rectangle. For safety reasons check whether the last marking has been determined accurately by reattaching the towel radiator.
- Drill holes on the marks. Now everything is ready to fix the device.
Concealed electric towel rail connection
Concealed connection (hidden installation). Called the installation of the electrical network in the wall, for a highly aesthetic appearance of the room and create safe conditions for the operation of electrical appliances, especially if the wiring is laid in the bathroom.
How to make a hidden connection of the electric towel dryer: tips for organizing the work
The convenience of using an electric towel rail is undeniable.
However, not everyone wants to have a cord in the bathroom for connecting the device to the socket in the open access.
In such a situation, it is possible to make a hidden connection of a towel dryer. It’s easy to do it with your own hands, first familiarizing yourself with the nuances of the installation process.
The box for the hidden connection of the towel dryer gold
At installation of electric models of towel dryers with a heating element for preservation of aesthetics of an interior the best variant to organize its latent connection. The box for the hidden connection of a towel dryer will allow you to plug the device in a hidden way and to hide the node of the power supply.
Advantages of a box for connection of a towel dryer The box for the hidden connection of a towel dryer has an unpretentious design, allowing thus to create a laconic interior in a room where the device is established, having excluded presence of unsightly power cables and electrical outlets. It provides not only an attractive appearance of the device, but also protects the connection point of the power cable from moisture. For the convenience of connecting the device to the network, the box is equipped with terminals.
The box of the hidden connection of an electric towel dryer has the following features:
- high-quality decorative coating gold
- anti-corrosion performance of brass
- convenience in the process of installation and connection of the towel dryer
- completed with a terminal block, dowels and screws and an installation manual
Delivery in Moscow within MKAD. 500 р. Outside the MKAD Ring Road 30/km.
Delivery of the goods is carried out 7 days a week, both during working hours and at weekends from 10:00 to 22:00. Delivery to the company’s office or to the customer’s address.
If the customer wishes to collect the goods, you need to clarify the completeness of the order. Notify time of the arrival to collect the goods.
Only after 100% payment by bank transfer through the transport company.
List of trusted transport companies.
To calculate shipping costs go to the website of the company by clicking the logo.
Address: c. Moscow Russia, Slavyanskiy Mir Construction Market “Melnitsa
Address: r. Moscow Russia, Slavic World Construction Market “Melnitsa
Item Code: 00229186 Manufacturer: Lemark Series: Pramen
Product code: 00220270 Manufacturer: Nika Series: Arc
At installation of electric models of towel dryers with a heating element for preservation of aesthetics of an interior of a premise the optimum variant. to organize its covert connection. The box for the hidden connection of the towel radiator will allow you to plug the device in a hidden way and hide the node of the power supply. Made of chrome-plated brass, it will perfectly match any heated towel rail models in chrome finish or with a glossy polished surface.
Advantages of the box for the connection of the towel dryer The box for the hidden connection of the towel dryer has an unpretentious design, allowing you to create a laconic interior in the room where the device is installed, except for the presence of unsightly power cables and electrical outlets. It provides not only an attractive appearance of the device, but also protects the connection point of the power cable from moisture. The box is equipped with clamps for easy connection of the device to the network.
The box of the latent connection of an electric towel dryer has the following features: anticorrosive execution from chromeplated brass; convenience at installation and connection of a towel dryer; complete set with a terminal block, dowels with screws and the instruction on installation.
In the Internet-shop of the Plumbing Shop you can buy “The box for the hidden connection of a towel dryer Nika” at the best price in Russia. The quality of the goods is confirmed by the certificate of quality and manufacturer’s warranty. Delivery “The box for the hidden connection of a towel dryer Nika” at the moment is not carried out. If you have any questions, please call 8 (800) 500-89-61.
Exchange and return
In order not to have problems with the return, you need:
- Keep the factory packaging, tags, trade dress, passport and warranty card (if any);
- Presence of the payment document (cash or commodity check etc.).д.).
Conventionally, all purchased items can be divided into two types: proper (satisfactory) quality and improper (unsatisfactory) quality.
In the first case, you can return the goods to the seller within 15 calendar days after purchase. The exchange will be done without any obstacles, based on the verbal request of the buyer.
If the product was purchased in the Moscow region, the return is made by the seller.
If the goods were purchased in any region of Russia (except Moscow), the return of the goods is at the expense of the buyer and the seller is not compensated.
After the goods are received, a return can be made within the next seven days.
Selling defective goods (not of proper quality) is a serious violation of trade rules. The law protecting consumer rights gives the right to demand from the manufacturer or the seller
- Exchange of the product for a similar one, i.e. of the same make, model and article number;
- Reduction of the price and return of a certain part of the money paid for the product;
- Return the money given to the seller as payment.
How to install a Towel Warmer with Control
The box for the hidden connection of the electric heater white
At installation of electric models of towel dryers with a heating element for preservation of aesthetics of an interior of a premise the optimum variant to organize its latent connection. The box for the hidden connection of the towel dryer will allow you to plug the device in a hidden way and disguise the node of the power supply in it. Made of metal, it will perfectly match the models of towel dryers with the color of covering white. The box for the hidden connection of the towel dryer provides not only an attractive appearance of the device, but also protects the connection point of the power cable from moisture. For convenience of connection of the device to a network the box is equipped with clamps.
The box of the latent connection of an electric towel dryer has the following features: • anti-corrosion performance; • Ease of installation and connection of a towel dryer; • completed with a terminal block, dowels and screws and an installation manual.
When installing electric models of towel dryers with a heating element to maintain the aesthetics of the interior of the room, the best option is to organize its concealed connection. The box for concealed connection of a towel warmer allows to plug up the device in a concealed way and to disguise the power supply unit in it. Made of metal, it will perfectly match the models of towel dryers with the color of covering white. The box for the hidden connection of the towel radiator provides not only an attractive appearance of the device, but also protects the connection place of the power cable from moisture. For convenience of connection of the device to a network the box is equipped with terminals.
Concealed electric heated towel rail connection box has the following features: • anticorrosive performance; • convenience in installation and connection of a towel dryer; • Complete with a terminal block, dowels and screws and installation instructions.
Delivery in Moscow within the Moscow Ring Road. 500 р. beyond the Moscow Ring Road 30/km.
Delivery of the goods is carried out 7 days a week, both during working hours and at weekends from 10:00 to 22:00. Delivery to the company office or to the customer’s address up to the entrance.
If the customer wishes to collect the goods himself, you need to specify the completeness of the order. Advise when to come to get the goods.
Is made through a transportation company only after 100% payment by bank transfer.
List of trusted transportation companies.
To calculate shipping costs go to the company’s website by clicking on the logo.
Address: d.o.o. Moscow Russia, Building Market Slavic WORLD “Mill”
Address: Moscow. Moscow Russia, Slavyanskiy Mir Construction Market “Melnitsa
Payment for ordered goods:
Individual persons:
- Online payments (bank transfer);
- Payment in cash at the offices (cash payment);
- Payment in any bank according to the details of the organization (cash/non-cash);
- Other ways of payment by agreement with the manager.
Legal persons:
- Bank transfer in any bank by requisites of the seller’s organization before shipment of goods;
- Cashless payment in any bank according to details of the seller’s organization under the post-payment agreement;
- Bank transfer in any bank according to the details of the seller’s organization under other conditions of the contract
Module connection
Attention! It is not possible to make the connection yourself. The device should be connected by a qualified technician. To realize the hidden type of wiring is possible only for electric towel heaters with the regulator on the rack. For models with a regulator on the plug, concealed wiring is only possible if an additional thermostat is used. Why? See the instructions below.
