How to clean the capillary pipe in the refrigerator. Instructions and tips
The capillary tube is the most important detail in the device of absolutely any refrigerator. Very often it is confused with a tube, which is located in the drainage opening inside the chamber and serves to remove excess moisture. But these are completely different details that have completely different functions. Often, the capillary breakdown leads to a complete failure in the operation of the refrigerator, so it is very important to control its condition and periodically clean it.
Bosch Refrigerator Complaints
The main purpose of the drainage system, consisting of a technical hole, a drain hose and a receiving tray, is a removal of moisture formed during the refrigerator:

- In household appliances that are equipped with a drop system of defrosting, condensation forms on the back of the chamber during the operation of the compressor;
- Moisture, subject to the functioning of the refrigerator in normal mode, flows along a special groove into a drainage hole;
- A plastic tube is attached to the hole, along which the liquid goes into the tank located on the compressor;
- The electric motor heats up during operation, due to which the evaporation of condensate from the tray into the surrounding atmosphere occurs.
IMPORTANT! The serviceability and normal functioning of the drainage opening contributes to the unhindered displacement of moisture from the refrigerator, as a result of which the condensate does not accumulate inside the refrigerator and does not flood the electric motor.
You regularly clean the refrigerator’s drain hole?
Where is?
The water drainage hole is located at the bottom of the rear wall of the refrigerator.
In devices equipped with the NOU Frost system, the drainage system is located behind a special panel on the back wall, therefore, in order to perform a preventive examination of the element of the device or do it clean, the protective panel must be dismantled.
Find out right now: how to defrost the refrigerator Bosch. Step.By.Step instructions for defrosting the refrigerator Indesite are presented here.

Otherwise) will not clean the drainage
If you want to keep the refrigerator in perfect condition, reduce (display) the spots of the elements of the drainage system, namely washing and disinfection, it is recommended to do every six months. Due to the fact that it will not work to avoid its pollution even with (all) one hundred percent of the correct placement of products and accuracy.
The elements of the system are constantly in contact with the water path and bacteria and fungi propagate on their surface. Among them, the cat did not cry potentially dangerous to health. If the drainage system is in poor condition, the following concerns occur in the refrigerator.
- A poor smell appears. At the same time, eliminating it does not mean thorough cleaning in the chambers, aromatizers, or disinfectors.
- Food breaks, mold appears on them, sticky coating. Safe storage period becomes damn small.
- When clogging the system, excess water can penetrate the finish and insulation to the metal parts of the case. This does not cause their corrosion in any month, but also deformations with a variety of consequences.
It is not necessary to clean the drainage hole, the refrigerator can become source of poor smell
And as who is said above, with the constant presence of excess water, the likelihood of short circuits and the exit from the formation of expensive and complex components of the refrigerator is very high.
The reasons for the clogging
Highlight the main causes of clogging. These include:
- Insufficiently frequent or poor.Quality refrigerator cleaning.
- Incorrect arrangement of products. If the food is laid close to the wall of the chamber, then food particles fall into the drain. This happens along with condensate that appeared from heating.
- Location of products without packaging or in insufficiently sealed packaging. Crumbs, particles of food and greens fall into the drain hole. Clog him.
All this does not allow moisture to leave as usual. Therefore, it is important to forget to clean the phone in the refrigerator.
How and how to clean the drainage pipe in the refrigerator
For cleaning you will need one of the tools:
- A special brush that is included in some models;
- Ear sticks;
- A large volume syringe or sprint;
- Subtle wire made of copper.
The process of cleaning the drainage opening looks like this:
- Pick warm water into the sprint (or into a syringe without a needle). Lean it tightly against the hole and sharply press on the tank with water. To not only clean the phone, but also get rid of the unpleasant odor inside it, you can add a small amount of vinegar or lemon juice to the water.
- Take a thin wire and gently pushing it inside the hole. You need to act very carefully so as not to damage the drain. Scroll through the wire periodically. 2-3 minutes enough to clean the drainage hole.
- With the help of ear sticks, only visible dirt can be cleaned at the beginning of the drain. They are not recommended to put them deep into the tube, since cotton wool can fly away and then a new, hard.To.Compile problem will arise.
- Cleaning drainage using a special brush does not imply anything complicated, since the tool is designed for such work. Usually, if it comes with equipment, it is suitable both in size and in length. If it was absent when buying, then it can be purchased in households or supermarkets of household appliances.
Cleaning the drainage pipe for draining excess water is actually very easy. The most important thing is to act carefully, not to rush and turn off the equipment from the network. If you doubt your abilities and are afraid to independently damage the device of water drainage, then it is better to contact the service center.
How to Clean Water Drip Pan of Refrigerator | Samsung 192L
Cases for calling the master
If the process of cleaning the opening of the drain does not give any results, then the case can be more serious for a more serious breakdown. We noticed that in addition to water formation, the compressor practically regularly works, and the freezer chamber is covered with a thick layer of ice, while the contents of the unit are poorly cooled, then there are likely the presence of several reasons: the seal on the door came into disrepair, the temperature sensor fails, the heating heater of the evaporator, and the evaporator heater and the evaporator and the evaporator and the heater, and so on.
Each indicated node of the refrigerator will require a replacement to make it, therefore, the most optimal option will be to call a mother for repairing refrigerators to the house, which will install the exact cause, and also do all the equipment repair work.
How to clean the drainage in nofrost refrigerators
In the Nofrost Drainage models, hold the refrigerator body behind the back panel. To clean such a system, it is recommended to contact the service basic. It is worth doing it yourself only with full confidence in your skills.
The advanced sign of clogging of drainage in the refrigerators of this class is a large layer of ice at the bottom of the freezer. This causes a decrease in cooling efficiency and increased compressor loads.
For cleaning the drainage in the refrigerator Nofrost, a specialist should be invited
Often, sometimes that moisture removal is disturbed due to freezing the tube and sections of the collection of condensate. It is recommended that before calling the master, it is recommended to defrost and completely de.Energize the formation for a period of at least 2 days.
The main function of the system
The main purpose of the drainage system, consisting of a technical hole, a drain hose and a receiving tray, is a removal of moisture formed during the refrigerator:
- In household appliances that are equipped with a drop system of defrosting, condensation forms on the back of the chamber during the operation of the compressor;
- Moisture, subject to the functioning of the refrigerator in normal mode, flows along a special groove into a drainage hole;
- A plastic tube is attached to the hole, along which the liquid goes into the tank located on the compressor;
- The electric motor heats up during operation, due to which the evaporation of condensate from the tray into the surrounding atmosphere occurs.
IMPORTANT! The serviceability and normal functioning of the drainage opening contributes to the unhindered displacement of moisture from the refrigerator, as a result of which the condensate does not accumulate inside the refrigerator and does not flood the electric motor.
You regularly clean the refrigerator‘s drain hole?
Where is?
The water drainage hole is located at the bottom of the rear wall of the refrigerator.
In devices equipped with the NOU Frost system, the drainage system is located behind a special panel on the back wall, therefore, in order to perform a preventive examination of the element of the device or do it clean, the protective panel must be dismantled.

Find out right now: how to defrost the refrigerator Bosch. Step.By.Step instructions for defrosting the refrigerator Indesite are presented here.
Function and structure of drainage
The drainage system needs a refrigerator to remove moisture. For models with a crying evaporator, this is condensate, which forms on the back wall of the refrigerator. At the bottom of the camera, in a special groove on the wall, there is a drainage hole. It is in it that all moisture should be normal.
Down from the hole, already outside the refrigerator housing, a plastic tube leads. On it, water flows into a special tray. It is located on the compressor housing.
When the motor heats up during operation, it heats the container with condensate, and it evaporates the kitchen in the air. Thus, the drainage of the refrigerator, with its simple structure, plays a crucial role. Moisture, scondmented from the air of the refrigerator, does not accumulate inside and does not fill the engine from the outside. Under the influence of natural physical processes, it is displayed out.
Materials and devices for quick cleaning of the drain hole
To speed up the cleaning process, you can use special devices. A ruff, brush. All of them can be bought at the refrigeration equipment store or in the plumbing department. Midial products will also be to help: cotton sticks, a piece of soft wire up to 0.5 m, knitting needle.
To rinse the hose, you can apply a sprint or a large syringe of a large volume. Dipping of the drainage hole can be made using a conventional bicycle nanosa
It is important to remember that, upon completion of all work, all surfaces must be carefully wiped dry
Materials and devices for quick cleaning of the drain hole