What do you get after the procedure?
A specialist, who performed the works, checks the operability of the device and draws up an act of its installation. This document is drawn up in two copies, one of which is left to the homeowner, the second takes away the performer of the work.
- place and date of installation of the counter;
- The factory number of the device;
- Information of a specialist who performed the installation;
- indicators at the moment of installation;
- The smooth running of the mechanism;
- The signatories (the installer and the owner of the premises).
Registration
With the signed installation act and the technical passport of the meter, the homeowner goes to the management company or the gas service to register the device. Here the initial readings of the meter are recorded, because during the installation a check of the working capacity of the meter was carried out.
Gas meters can be installed either free of charge or not?
Initial stage
- After the gas company approves the chosen meter model and purchases it.
- The package of documents is prepared
- Application for installation,
- Gasification plan,
- Copy of a document certifying the identity of the owner,
- Documents for the appliance itself,
- Subscriber’s book,
- Maintenance contract.
Installation phase
Gas meters are installed by licensed specialists. An installer is invited to install the meter. They make a sketch of the meter, check the condition of the gas pipes, make an estimate, remove the old equipment and if necessary, do some technical works.
After the installation the owners get the Act of executed works. The meter is sealed by the managing company within three days and the owners must apply to the company.
Registration
Installed equipment must be registered at the gas service. To do this, fill out an application, enclose copies of documents (passport of the device and its test certificates), in some services may additionally require the passport of the owner. Once in 6 months the service can check the condition of the device.
For a fee
There is a charge for meter installation, and the meter installation is paid for by the owner. Even in the situation of installation by the service Gorgaza will have to pay the cost of the meter and additional elements of installation.
To buy the meter itself costs from 2000 to 15000 depending on the chosen model, manufacturer’s country and the meter’s capacity, the fastening elements cost about 1000, depending on the region and organization engaged in the installation.
The total cost will be in the range of 4000. 19000.
IMPORTANT: Only tested and sealed meters can be installed
Free installation
Free installation of meters is carried out for the following categories of citizens:
Where you can move the gas meter?
It is quite simple to choose a place for relocating the meter in the apartment, but you must remember about its accessibility for maintenance and compliance with safety requirements.
According to SP 42-101-2003 gas inspectors have the right to require compliance with the following standards:
- The minimum distance between the meter and the radiator is 1 meter;
- The meter must be installed at a height of 50 to 160 cm from the floor;
- The minimum distance from the stove to the counter is 40 cm and from the wall 4-5 cm;
- The device must not be exposed to direct sunlight or moisture, the housing must not be exposed to high temperatures.
If you decide to take the meter outside or other structure, then the following requirements must be met:
- The counter should be installed under a shelter or in a special locker, which must be ventilated;
- The gas meter cannot be installed in the exterior wall openings of the house. in case of a leak, gas will accumulate there;
- the minimum distance from the device to the windows and doors is 50 cm
- installation is allowed if the temperature will not rise above 60 degrees and fall below 20 degrees;
- The meter must be equipped with a thermal corrector.
Before choosing a location, it is advisable to consult with professionals.
Rules of gas accounting
Payment for the gas supplied must be made monthly, by the 10th day of each month.
If you have a gas meter
Payment for the supplied gas is made on the basis of payment documents, which are sent by Gazprom Mezhregiongaz Moscow to each subscriber. The Consumer shall enter meter readings into special columns in the payment document:
| Previous | Current | Date |
| 1000 | ||
| To be paid: | Other sum | |
| 1590 | ||
| Payment date | 2420.00 Subscriber’s signature | |
| Date of reading | H/m meter reading (m3) | Difference in readings (m3) | Accrued | Benefit | Arrears | Total payable (.) | In t.ч. ration (.) |
| 01.12.2008 | 1000 | 2420,00 | 2420,00 | 2420,00 |
If a meter reading is not recorded on the receipt, the consumed gas will be charged according to the current legislation
If all citizens residing in the dwelling premises (residential building) are absent at this place of residence for more than 1 month and cannot submit gas meter readings, the subscriber shall notify OOO Gazprom Mezhregiongaz Moscow by e-mail indicated on the reverse side of the gas receipt.
| Consumer area | F0509110@gazmsk.ru |
| Consumer area | F0509210@gazmsk.ru |
| Subscriber area | F0509310@gazmsk.ru |
| Subscriber area | F0509410@gazmsk.ru |
| Consumer area | F0509510@gazmsk.ru |
How much does it cost to install a gas meter in a private home
Owners of private homes who have decided to abandon traditional heating stoves and use gas to heat their homes, cook food, and provide hot water, should seriously consider metering their gas consumption. meters. Naturally, acquisition, installation and use of such device will require certain expenditures, and sometimes they are quite sensitive.
Therefore, before making a final decision, you should be thoroughly familiar with the parameters that affect the costs that this procedure entails.
Installation of a gas meter in g. Moscow and Moscow. area
6.It is recommended to install gas flow meters (nodes):
6.It is allowed to use residential gas meters as gas meters, the location of which is regulated by this subsection 6.1.4 of this Regulation.
6.47 Meters are to be installed with due consideration of the conditions of their easy mounting, service and repair. As a rule, the height of the meters should be 1.6 m above the floor or the ground. 6.47 In order to exclude the corrosion damage of the meter’s coating when installing the meter, a space (2-5 cm) between the meter and the construction of building (construction) or supporting structures should be envisaged.
6.49 Installation of meters indoors is foreseen outside heat and moisture generating areas (from a stove, a sink, etc.).п.) in naturally ventilated places. It is not recommended to install meters in stagnant areas of the premises (parts of the premises fenced off from ventilation ducts or windows, niches, etc).п.).
The distance from the installation places of the meters to the gas equipment I! in accordance with the requirements and recommendations of the manufacturers as stated in the meter passports. In the absence of the above requirements in the passports, the placement of meters should be provided, as a rule, at a distance (radius) of at least:
6.Installation outside (outside the building) of meters is performed under shelters, in cabinets or other constructions that protect meters from external influences. The open counter is allowed to be set. Placement of the meter provide:
Installing natural gas service: New home construction
It is not recommended to place the meters under a wall opening.
6.51 The construction of the switchboard must allow for natural ventilation. Doors of the cabinet must have locks.
For the installation of gas meters, there are several different organizations. Their employees do their part, and subscribers just need to choose the most acceptable option. Gas meters are installed strictly according to the rules, you can not act alone.
They are installed by employees of gas distribution companies and licensed employees of organizations. Self-installation is more likely to end in equipment damage or explosion.
In the case of successful installation the control authorities will not seal the device anyway, and will write a big fine for exposing others to risk. By doing so they will comply with paragraph. 5.5.2 Ordinance 70 of the State Building and Housing Committee. Gas meters are installed based on the norms of Federal Law 61, which came into force on 29.06.2015 and require the use of a gas meter in rooms with individual heating appliances.
Owners of such premises and those simply wishing to do so have several options to address:
A master gas fitter will not install a meter on a pipe with a surface temperature above or below 60 °C.20 °C. The installer may require the homeowner to move the stove away, even if it is at a safe distance. Disputes between the parties often arise on this ground, but it can be resolved simply by moving the stove forward. The same requirements are applied to the ambient conditions, although there are no rooms with such temperatures in residential buildings.
Gas fitter will start to install the meter when there are no technical obstacles left and from this moment the gas fitter should control the process.
The device is attached only in an accessible place, regardless of the opinion of the tenants. In turn, there is nothing to stop owners from ordering the installation in a half-empty kitchen, and then. short-circuiting the meter in the hanging furniture. There will be no wrongdoing in such actions, because the supplier’s representative will be able to see the readings. In this sense, the owners sometimes cause inconvenience to themselves. In order to take the readings himself or allow the inspector, you will have to repeatedly move objects or take everything out of the kitchen cabinet. Therefore, in order not to have to move the gas meter in the future, it is better to place it in an accessible place.
It is not worth agreeing to an additional waste of time if the master is against installing the meter on a curved section of pipe. Indicators of the device does not depend on its shape.
The location of the meter affects the convenience and appearance of the room. The device is inserted into the pipe in any way the consumer wants, vertically or horizontally.
The installer determines the place of installation and indicates the cost of the work. The price is affected:
Norms are determined for safety and functionality of the device. Masters of gas installation observe SP 42-101-2003. General provisions for the design and construction of gas distribution systems of metal and polyethylene pipes. So, based on paragraph 6.49 these rules, you can install the gas meter outside areas with a high emission of moisture or heat. These include the stove and the space above it, boiler, sink. And the minimum distance from the meter to the gas boiler and to the stove is clearly defined.
In terms of the correctness of the readings, it does not matter if there is a gas or electric appliance nearby. If heat or moisture is coming from it, attention is also paid to the temperature and humidity. Exact norms concern only the gas equipment.
For installation choose only places with good natural ventilation, and the forced in this case will only be a plus. Areas with stagnant air are not suitable. The quality of the latter is determined by feeling.
Air conditions worsen in remote areas of rooms, areas behind partitions, niches. Options at a significant distance from the window and ventilation or with barriers in their direction are not suitable.
During the work, the installers use the information in the passports of the meters. Manufacturers specify their recommendations and general requirements about the models of gas meters, minimum and maximum distances. Gas inspectors do not always rely on technical data, but act according to the situation. If the manufacturer has not provided any requirements for the intervals, the installer must comply with the following universal parameters:
- The installation height standard is 160 cm. In the rules, this figure is advisory, not mandatory.
- The margin to the wall must be at least 3 cm, and preferably 5 cm. The gap between the meter and the vertical surface is sometimes called corrosive and provides for at least 5 cm in case of damage to the meter.
- Do not leave less than 80 cm distance to the nearest gas-using device. We are talking about gas-fired heating appliances and the same household stoves. This category includes heat generators, boilers, flow-through and tank water heaters.
The distance is not measured from any point and in any direction. The radius interval from the gas meter is taken into account. Scientifically speaking, it should be installed in such a way that the minimum distance of the nearest points on the uninstalled meter to the same points on the devices should be maintained in all three axes. Then there will definitely be no mistakes with the intervals. Between the side edges of the stove and the gas meter should be left at least 5 cm, three times the distance from the gas meter to the gas boiler or column. The level of placement should be no lower than 40 cm above the top edge of the stove and no closer than 15 cm from the top or bottom edge of the water heater.
What to pay attention to when choosing a gas meter
When buying a gas meter for outdoor installation one should pay attention to the specifications, especially regarding the permissible temperature conditions in winter time. You need to compare whether the device can operate at the minimum air temperature in the climatic area of its location.
Besides, one should pay attention to the gas throughput capacity of the meter. It should be higher (but not more than 30%) than the total consumption of all devices operating at full load.
If installing gas flow meters outside they will need a special case where they will be fixed. It is a requirement of operating rules of gas equipment, to protect the meter from adverse effects of the atmosphere, as well as for vandal-proof protection from intruders.
The place of installation is coordinated with the gas supply company, and the work is performed by an organization that has a license to carry out installation work on gas equipment.
Where to apply
Before you contact a professional, you must purchase a device. It must have a technical passport and a certificate of compliance.
ATTENTION! Substitution of gas and metering devices by yourself is prohibited by law.
Only specialists of the gas service or commercial organizations that have a license can perform this kind of work. In order for the installation to be free of charge, you must follow the following algorithm of actions:
- To make an application in Gor Gas. It must be accompanied by a copy of an identity document, proof of ownership of the living space;
- Gas technicians come to the specified address to assess the state of the gas pipeline and agree on the place of installation of meters;
- to give the metering device to be installed;
- Sign the act on the performed installation work;
- To register a measuring device.
You can do this by informing the management company about the installation of gas meters. After that, an inspector will come to the apartment, who will assess whether the device is properly installed and seal it.
Installation of gas meters: types, description and selection criteria for devices
In accordance with Federal Law 61, private households and residential premises in multi-storey buildings must be equipped with gas meters. This measuring device belongs to the domestic equipment, the installation of gas meters can only be carried out by special companies that have a license to do so. But before you install a meter, you need to choose it correctly, as well as to know certain nuances, which are specified in the legislation.
